CUBORG

Just posted this on thingiverse let me know what you think it is a modular organizer comes with a cube side panels dividers and drawers.

Let me know what you think

http://www.thingiverse.com/thing:95854

 

Nice Jeff! Downloaded them. Looking forward to printing

 

Way to go Jeff! That is a lot of pieces.

 

Thanks Printed, One thing nice about the drawers was once I made one I could simply resize the first part extrusion from the 2d drawing that make the actual drawer part of the drawing and it does affect any other part so make one resize one part got another resize got another etc. all 16 of them.

 

They do connect. What you see is the product with the all the covers on, you can remove any of the covers and attach another module. The Second pic shows how three can be connect but it can be in any arrangement you want it comes with the .stls for all the side, top and bottom covers the main box and all the dividers and drawers

 

I am waiting for a rendered image to finish which will be the main image when it gets done but I may add another lo-res without some of the covers.

Each cover has the same connections as the corresponding box side so that taking a cover off will allow you to put a new box in its place but then of course based on where you put it you may need another cover piece to finish it off.

Total modularity

 

Rendered image is now up ... Check it out


http://www.thingiverse.com/thing:95854

 

I hope all of you like it but be fore warned I do not have a printer so it has never been printed.

That being said I did use the mates features on SW to put the piece together for that rendered image and everything seemed to fit nicely but things MAY be a little tight