1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Driver wont work HELP!!1

Discussion in 'Troubleshooting' started by Salvatore Lacorte, Apr 16, 2018.

  1. Salvatore Lacorte

    Salvatore Lacorte Member

    Joined:
    Apr 8, 2018
    Messages:
    47
    Likes Received:
    3
    I have been working on my robo for a while and i am stuck because my drivers wont allow my motors to move freely. One motor wont move and the other wont go backwards. I am stuck. All help appreciated
     
    #1 Salvatore Lacorte, Apr 16, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sounds like the end stops are triggering. When one tries to go "backwards" it thinks its home so wotn go any further. The motor that wont move I'd look into making sure it didn't come unplugged (from both the motor and the board). What "work" have you been doing on the R1? Without knowing what you've done its really a guessing a game on our end. As always if you need more involved help you can always reach out to Robo Support and skype with them so they can lay eyes on it.
     
    #2 Geof, Apr 18, 2018
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Pictures or it never happened.
     
    #3 WheresWaldo, Apr 18, 2018
    Geof likes this.

Share This Page