1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

EZStruder X Carriage

Discussion in 'Mods and Upgrades' started by Leon Grossman, Aug 10, 2013.

  1. scotta

    scotta Active Member

    Joined:
    Feb 20, 2013
    Messages:
    187
    Likes Received:
    96
    Did you use the stepper motor from the original Robo3d. I've not even looked the rating of it.
    EZ struder uses a Nema 17?
     
  2. Leon Grossman

    Leon Grossman Active Member

    Joined:
    Feb 20, 2013
    Messages:
    226
    Likes Received:
    123
    Yes, I reused the Robo stepper motor. The stepper motor is plenty strong enough for 80mm/sec (the fastest I've tested so far). You could use a bigger stepper motor but that would eat into more of your build platform.
     
    2 people like this.

Share This Page