1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Filament broke, trying to refeed

Discussion in 'Printing Filament' started by Terry Coward, Jan 14, 2020.

  1. Terry Coward

    Terry Coward New Member

    Joined:
    Jan 14, 2020
    Messages:
    1
    Likes Received:
    0
    Good afternoon,
    My name is Terry and I using the R1 Robo 3d. Filament broke so I have been trying to refeed the filament.
    I have got all of the old filament out but the new filament is not feeding though.
    I have any desk on my laptop. which can be remoted into if someone can help me.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,722
    Likes Received:
    7,085
    https://help.robo3d.com/hc/en-us/articles/115001259472-Loading-filament

    If that doesn't cover you then more details :) You may have a bit stuck inside the feed (under the hobbed bolt). Or it is not lined up correctly once it gets past the hobbed bolt to feed into the top of the hotend. Pictures would be helpful (you can host them on imagur or flickr and post a link)

    P.S. Welcome to the forum.
     

Share This Page