1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Filament run out lcd screen.

Discussion in 'Software' started by jscottb, Nov 14, 2017.

  1. jscottb

    jscottb Member

    Joined:
    Sep 10, 2017
    Messages:
    45
    Likes Received:
    26
    I have had the Filament run out lcd plug-in screen to lock up twice now. Out of 4 times of running out of finament, it's do this. Octo still responds from the RPI and you can resume from there with no issues. Is this a known issue?

    It just sits at this screen

    filament.jpg
     
    #1 jscottb, Nov 14, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Nov 14, 2017
    Geof likes this.
  3. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    424
    Likes Received:
    111
    Robo is sending me a new cable. Apparently there is an issue where they think the wires in the original cable didn’t get crimped too well to the sockets that are in the connector that goes on the pi.
    I’ll let you know how things turn out.
     
    #3 supercazzola, Jan 27, 2018
    mark tomlinson likes this.

Share This Page