1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

filament settings, best/worst brands, etc.

Discussion in 'Filament' started by mark tomlinson, Dec 29, 2020.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,880
    Likes Received:
    7,261
    This is for details about filament brands, types, settings and the like
     
  2. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    353
    Likes Received:
    137
    I print the same 7 items over and over on 3 printers. I usually have to print about 20 items of a type while adjusting settings with a new filament before I am satisfied with the result or reject the filament. The only filament I have found so far that will print all 7 items with acceptable strength and finish is eSun. eSun is sold by Walmart under 3Dbison. The next best filaments are Sunlu and Hatchbox which can print 5 of my items acceptably.

    I have many filaments that are acceptable for most of my other casual printing and I am hoping to open a discussion on brands and settings so that we can all share the information.

    I have started looking for manufacturers in the USA as I much prefer that to China and will report back results.
     

Share This Page