1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Firmware help

Discussion in 'General Questions' started by 3ddder, Jun 22, 2015.

  1. 3ddder

    3ddder New Member

    Joined:
    Aug 3, 2014
    Messages:
    19
    Likes Received:
    0
    Hello everyone. So I downloaded firmware 3.0 to make sure my new r1 is up to date, but while going through the instructions, it says to choose the sketch "marlin auto level". I can't find it though. I just see Robo3dr1v3_06_11 with a ton of files in it, which all seem to be different sketches. What am I doing wrong?
     
    #1 3ddder, Jun 22, 2015
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Yeah, the Robo guys don't seem to check their work very often. There is a .ino file in the directory, that is the file you want to load. It will then load all the corresponding and necessary files in the compiler automagically. At that point you will be ready to compile and upload.
     
    #2 WheresWaldo, Jun 22, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    load the .ino file not named "Marlin.ino" and is the same name as the parent folder

    They should be updating the instructions.
     
    #3 Mike Kelly, Jun 23, 2015

Share This Page