1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Fixing stringing for better prints

Discussion in 'Troubleshooting' started by Soupaboy, Dec 9, 2013.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. Soupaboy

    Soupaboy Active Member

    Joined:
    Sep 29, 2013
    Messages:
    287
    Likes Received:
    49

    I think it is quite good becuase of the bed levelling but I cannot say too much as I have not fully used it. I will check out cura over the weekend, I have it but never used it
     
    #21 Soupaboy, Jan 20, 2014
  2. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    I'm doing a test print using Cura now. One thing I have to say over Repetier-Host, Cura is freaking fast. Don't know if that's a good or bad thing yet.
     
    #22 Melody Bliss, Jan 20, 2014
  3. warlocke

    warlocke Active Member

    Joined:
    May 10, 2013
    Messages:
    127
    Likes Received:
    58
    Matter Control != Linux Compatible
     
    #23 warlocke, Jan 20, 2014
  4. tompeel1

    tompeel1 New Member

    Joined:
    Apr 18, 2013
    Messages:
    78
    Likes Received:
    17
    Tonycstech any tips or guides on setting up CURA for the Robo?
     
    #24 tompeel1, Jan 28, 2014
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    MatterControl may run in Wine. If not, it runs in VMware so the linux version of player would work...
     
    #25 mark tomlinson, Jan 28, 2014
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page