1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Had trouble but then...

Discussion in 'Off Topic' started by f16falcon6, Dec 21, 2015.

  1. f16falcon6

    f16falcon6 New Member

    Joined:
    Dec 9, 2015
    Messages:
    3
    Likes Received:
    2
    So for two weeks after purchasing my R1 I went through the most troublesome times with my printer. No matter what I did I could not get a soccessful print. Then I discovered the fan over the ramps board was broken. After fixing the fan something amazing happened. The printer began printing beyond expectations. This printer is amazing. For those that are having issues. Do t give up on it. It does an amazing job.
     
    mark tomlinson and Mike Kelly like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    That fan can be a real issue. It is quiet anyway so if it stops you may not notice it.
    Glad you found and sorted it out.
     
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    Glad to hear you got it sorted as well. Message me again if you need more help, getting ready for the holidays has kept me quite busy
     

Share This Page