1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved heat bed shift during print

Discussion in 'Troubleshooting' started by mmartin6969, Jul 2, 2017.

Thread Status:
Not open for further replies.
  1. mmartin6969

    mmartin6969 New Member

    Joined:
    Jul 1, 2017
    Messages:
    4
    Likes Received:
    2
    i just got my r1 3 days ago printed a couple small things just fine, but when i try something larger the bed shifts 3-5mm. first time shifted forward the last time it shifted back is this a motor voltage issue?
     

    Attached Files:

    #1 mmartin6969, Jul 2, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    That much shift is probably a loose belt
     
    #2 mark tomlinson, Jul 2, 2017
  3. mmartin6969

    mmartin6969 New Member

    Joined:
    Jul 1, 2017
    Messages:
    4
    Likes Received:
    2
    seems tight but i will try make it tighter
     
    #3 mmartin6969, Jul 2, 2017
  4. mmartin6969

    mmartin6969 New Member

    Joined:
    Jul 1, 2017
    Messages:
    4
    Likes Received:
    2
    ok i was able to tighten belt by a couple of teeth, i have a print going now will see how it goes.
     
    #4 mmartin6969, Jul 2, 2017
  5. mmartin6969

    mmartin6969 New Member

    Joined:
    Jul 1, 2017
    Messages:
    4
    Likes Received:
    2
    succsees. thank you mark tomlinson
     

    Attached Files:

    #5 mmartin6969, Jul 2, 2017
    Geof and mark tomlinson like this.
Thread Status:
Not open for further replies.

Share This Page