1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

High spot

Discussion in 'Troubleshooting' started by lichaem69, Aug 23, 2014.

Thread Status:
Not open for further replies.
  1. lichaem69

    lichaem69 Member

    Joined:
    Apr 15, 2014
    Messages:
    71
    Likes Received:
    8
    I got new draw rails, and now my robo3d seems to be leveled a lot better, but I still have 2 high spots on my bed that is causing the plastic not to stick to those areas. Are there any suggestions for this?
     
    #1 lichaem69, Aug 23, 2014
  2. lichaem69

    lichaem69 Member

    Joined:
    Apr 15, 2014
    Messages:
    71
    Likes Received:
    8
    #2 lichaem69, Sep 11, 2014
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Can't tell from the video specifically, but it looks like the layer being put down is too high.
     
    #3 mark tomlinson, Sep 11, 2014
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    looks like your calibration is wrong. I'd repeat the process.
     
    #4 Mike Kelly, Sep 11, 2014
Thread Status:
Not open for further replies.

Share This Page