1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

HotEnd Heat Sensor Issue

Discussion in 'Troubleshooting' started by Steve Marco, Oct 26, 2014.

Thread Status:
Not open for further replies.
  1. Steve Marco

    Steve Marco New Member

    Joined:
    Jun 7, 2014
    Messages:
    20
    Likes Received:
    0
    Hey Guys,
    The thermometer sensor (white wires connecting to the hot end) of my R1 got damaged. Do you have any thoughts as to where I can get a replacement? I'm trying not to have to purchase the entire hot end (as it still works ok)

    Thanks,
    Steve
     
    #1 Steve Marco, Oct 26, 2014
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #2 mark tomlinson, Oct 26, 2014
  3. Printed Solid

    Printed Solid Volunteer Admin
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    1,605
    Likes Received:
    1,003
    I actually only sell a stud mounted thermistor. It mounts directly to an existing hole on the E3D V6 hot end, but you need to tap one of the holes on the Hexagon. Aside from the fact that it is quite a bit more rugged than a stand alone thermistor, you also have the benefit of a secure threaded mount of the thermistor into the heat block rather than holding it in with tape or fire cement.
     
    #3 Printed Solid, Oct 26, 2014
    2 people like this.
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #4 Mike Kelly, Oct 27, 2014
Thread Status:
Not open for further replies.

Share This Page