1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved How do I get a replacment rubber cover?

Discussion in 'Troubleshooting' started by wthierry, Dec 3, 2015.

  1. wthierry

    wthierry Active Member

    Joined:
    Dec 22, 2014
    Messages:
    185
    Likes Received:
    54
    I had a large print fail last night, and you can see from the pic that the PLA has gummed up and wrapped itself around the cover. I cannot seem to get it out. Please help! Its Robo3d R1 with auto level.[​IMG]
     
    #1 wthierry, Dec 3, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Call Robo or email their replacement parts folks:

    http://robo3d.com/warranty/


    However you can make sure the thermistor is correctly positioned and just wrap the hotend heater block in kapton tape and that will serve the same purpose.
     
    #2 mark tomlinson, Dec 3, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Down side to hexagon is spare parts availability (or rather : there are no spare parts available).
     
    #3 mark tomlinson, Dec 3, 2015
  4. daniel871

    daniel871 Well-Known Member

    Joined:
    Apr 18, 2015
    Messages:
    1,322
    Likes Received:
    510
    Kapton Tape or RTV sealer coating.
     
    #4 daniel871, Dec 3, 2015
    Mike Kelly likes this.

Share This Page