1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered How do you move a print on the bed?

Discussion in 'General Questions' started by TheGastlyGuy, Jun 24, 2016.

  1. TheGastlyGuy

    TheGastlyGuy New Member

    Joined:
    Jun 12, 2016
    Messages:
    10
    Likes Received:
    0
    I have tried going into the print to move it and then saved it. From there I would take the g-code and put it into an sd card and when it prints the first layer it prints partially off of the heated bed. What could be the issue here? am i doing this wrong?

    *using mattercontrol
     
    #1 TheGastlyGuy, Jun 24, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sounds like your z offset is to big.

    I dont use matter control so i cant help further.
     
    #2 Geof, Jun 24, 2016
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Check your startup GCode and adjust the value for the M565:

    M565 Z-1.0 ; set the offset for auto-leveling mechanism more negative ->further from bed

    Adjust it in small increments (0.1 or 0.01)

    how specifically this is done in mattercontrol I can't say.

    However less negative ->closer to the bed...
     
    #3 mark tomlinson, Jun 24, 2016
    Geof likes this.

Share This Page