1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

I got the robo 3d r1 but the prints have been horrible.

Discussion in 'General Questions' started by Jadynisawesome, Aug 16, 2015.

  1. Jadynisawesome

    Jadynisawesome New Member

    Joined:
    Aug 16, 2015
    Messages:
    6
    Likes Received:
    0
    Hey guys,
    I recently go the r1 and ive printed a few parts but the prints have been stringy and have almost not accuracy. It looks like a uncooked ramen noodle square. Any tips? I'm going to try cura for the first time but im not sure what else to do
     
    #1 Jadynisawesome, Aug 16, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Z offset is too high.
    The filament should be pressed on the build plate, not dropped.
    It should be rather flat...
     
    #2 mark tomlinson, Aug 17, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #3 Mike Kelly, Aug 17, 2015

Share This Page