1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved I just got my 3D printer 8 hours ago, but I can not print anything successfully.

Discussion in 'Troubleshooting' started by Wis Wang, Mar 16, 2015.

  1. Wis Wang

    Wis Wang New Member

    Joined:
    Mar 10, 2015
    Messages:
    10
    Likes Received:
    1
    I wonder why my 3D printer stop working every time when it's printing.
    I'm using PLA, extruder at 210c and bed at 50c. The Software is MatterControl1.2
    I've tried to cancel the print, clean off the bed, and start over again. As a result, it's the same.
    I am a noob for 3D printer what happened to me was not in the STARTED VIDEO.

    IMG_3124.JPG IMG_3123.JPG IMG_3122.JPG
     
    #1 Wis Wang, Mar 16, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    That's usually a computer problem disabling the USB ports or something along those lines.

    You're also too high. Reduce your Z offset.

    Use this guide to print from SD: http://wiki.mattercontrol.com/Export_to_SD
     
    #2 Mike Kelly, Mar 16, 2015
  3. Stephen Capistron

    Stephen Capistron Active Member

    Joined:
    Jan 28, 2015
    Messages:
    442
    Likes Received:
    154
    The USB connection is pretty weak on this. The board is a USB hog and the physical connection is pretty poor as well. I have my cord literally screwed into place with a bracket. Others eventually move to printing from the SD card. But I would walk before you try running.
     
    #3 Stephen Capistron, Mar 17, 2015
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #4 mark tomlinson, Mar 17, 2015
  5. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    I had issues with mine while I was streaming camera. Started printing from SD card and no longer have those kinds of issues
     
    #5 jbigler1986, Mar 17, 2015
  6. Wis Wang

    Wis Wang New Member

    Joined:
    Mar 10, 2015
    Messages:
    10
    Likes Received:
    1
    Thanks a lot guys. Finally, it works! :)
     
    #6 Wis Wang, Mar 18, 2015

Share This Page