1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Installing Kickstarter 3D printer filament detector and cleaner

Discussion in 'Troubleshooting' started by James H Coffey, Jun 6, 2017.

  1. James H Coffey

    James H Coffey New Member

    Joined:
    Jun 6, 2017
    Messages:
    1
    Likes Received:
    0
    Has anyone on this forum purchased and installed the Filament Sentinel (Kickstarter) by DYZE Design?

    I have purchase one, but have no idea how to connect it to my R1+. DYZE has a posting about installing, but I am not tech enough to figure it all out. They discuss installing wiring on specific pin locations. I have no schematic to know where the board is and what the pin numbers are. If anyone has done this and/or can provide me with help, let me know.
     
    #1 James H Coffey, Jun 6, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I dont know of anyone that has but there is a filament run out that @danzca6 put togather (in mods and upgrades section). If you'd like to add links to all your info someone may be able to take a look at it?
     
    #2 Geof, Jun 6, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    There are some posts from @Ziggy back when he was active. He designed one as well that is almost identical to what the C2/R2 use now. A very few bucks in parts and a minor mod to the firmware/ramps
     
    #3 mark tomlinson, Jun 6, 2017
    Geof likes this.

Share This Page