1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Is Robo3d firmware custom

Discussion in 'Troubleshooting' started by Chris Rodriguez, Apr 14, 2015.

  1. Chris Rodriguez

    Chris Rodriguez New Member

    Joined:
    Nov 17, 2014
    Messages:
    23
    Likes Received:
    12
    Just wondering if anyone knew off the top of their head.

    Is the version of Marlin that Robo3d uses customized(and by customized I mean other than setting certain config values)? I was just trying to see if someone knew off the top of their head without having to pour over the source code.

    Just wondering as I am working on a custom firmware for a project and just wanted to know if I could use my Robo3d as a test bed without lots of customizing to fit the printer.

    Thanks,
    Chris
     
    #1 Chris Rodriguez, Apr 14, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Other than the geometry settings in CONFIGURATION.H it is not customized that I am aware of.
    @Ziggy has looked at this a lot closer.
     
    #2 mark tomlinson, Apr 14, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    The only modification they implemented was a temp fall error to catch a thermistor dropping out leading to a thermal run away.

    Besides that it's just basic geometry modifications
     
    #3 Mike Kelly, Apr 14, 2015
  4. Chris Rodriguez

    Chris Rodriguez New Member

    Joined:
    Nov 17, 2014
    Messages:
    23
    Likes Received:
    12
    Sounds good guys. Thanks for clarifying that info.

    I assumed it wasn't a bunch of changes but didn't want to have to diff all those files.

    Thanks,
    Chris
     
    #4 Chris Rodriguez, Apr 14, 2015
  5. Stephen Capistron

    Stephen Capistron Active Member

    Joined:
    Jan 28, 2015
    Messages:
    442
    Likes Received:
    154
    If you search "robo" in the firmware that should bring you to all of the settings they went with.
     
    #5 Stephen Capistron, Apr 15, 2015
  6. Chris Rodriguez

    Chris Rodriguez New Member

    Joined:
    Nov 17, 2014
    Messages:
    23
    Likes Received:
    12
    Stephen,
    Nice tip!

    Thanks,
    Chris
     
    #6 Chris Rodriguez, Apr 15, 2015
  7. Ziggy

    Ziggy Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    707
    Likes Received:
    530
    But stay with Marlin versions which have been released by Robo. Later version of Marlin on GitHUB have many updates/modifications which are very buggy right now.
     
    #7 Ziggy, Apr 15, 2015

Share This Page