1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Laybrick filament

Discussion in 'Printing Filament' started by Jack_Adamczuk, Jun 22, 2014.

  1. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    I just finish test on Laybrick filament.

    Head temp. 180
    Bed temp. 55 (first 3-4 layers) after, 45

    (!!!!!!!!!!!!!!) You need to split in start G-CODE : M227 S30000 P10000
    AFTER PRINT WAIT 1h, and remove print !!!! DO NOT IGNORE THIS !!!

    Layer after layer and smile :)

    laybrick.jpg
     
    #1 Jack_Adamczuk, Jun 22, 2014
    3 people like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    nice...
     
    #2 mark tomlinson, Jun 22, 2014
  3. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    what is the density of that filament is it close to the same weight as other PLA or is it heavier the print looks great but was curious about its weight.
     
    #3 tesseract, Jun 22, 2014
  4. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    #4 Jack_Adamczuk, Jun 22, 2014
  5. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    I guess I was too formal I don't need the actual spec just a generic is it heavier than PLA or lighter
     
    #5 tesseract, Jun 22, 2014
  6. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    the same, but if you touch it you feel chalk print and not plastic
     
    #6 Jack_Adamczuk, Jun 22, 2014
  7. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    very cool I love trying out new filaments and that one is on the list
     
    #7 tesseract, Jun 22, 2014
  8. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    forgot were you using the same nozzle size .4mm??
     
    #8 tesseract, Jun 22, 2014
  9. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    0.4 mm
     
    #9 Jack_Adamczuk, Jun 22, 2014

Share This Page