1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Layer Jumping

Discussion in 'Troubleshooting' started by Eion Frakes, Feb 14, 2018.

  1. Eion Frakes

    Eion Frakes New Member

    Joined:
    Feb 14, 2018
    Messages:
    1
    Likes Received:
    0
    I just bought my R+ and did some test prints to get it broke in. I then did the whistle and everything was going fine until it went to to the closing layers and it shifted y+ 1mm. I was also doing 2 other prints when it was an hour in a jumped x- 1mm, and the other 20 minutes in when it jumped y+ 1mm again. Does anyone know if this setting or something else?
     
    #1 Eion Frakes, Feb 14, 2018
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Two things to check both easy, make sure the set screws holding all the belt gears are fully set and tight. There is a fan attached to the bottom of the printer make sure it is spinning 100% of the time.
     
    #2 WheresWaldo, Feb 14, 2018
    Geof likes this.

Share This Page