1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved legs going wild

Discussion in 'Troubleshooting' started by eric tobin, Jan 14, 2018.

  1. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    ok, this s happening on almost all of my prints of horses, deer, and elk. some are worse , others not so bad. happens with pla and abs. I have tinkered with the temps , going up or down by 5-10 degrees with no noticeable changes. any ideas.
     

    Attached Files:

    #1 eric tobin, Jan 14, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    The print head appears to be knocking over the legs
     
    #2 Geof, Jan 14, 2018
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #3 mark tomlinson, Jan 14, 2018
    Geof likes this.
  4. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    thank you all very much
     
    #4 eric tobin, Jan 14, 2018

Share This Page