1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered MAC and Mattercontrol

Discussion in 'Troubleshooting' started by momoe, Jan 19, 2016.

  1. momoe

    momoe Member

    Joined:
    Apr 23, 2015
    Messages:
    74
    Likes Received:
    7
    Anyone else have mattercontrol act unstable on their MAC?
     
    #1 momoe, Jan 19, 2016
  2. woferry

    woferry Member

    Joined:
    Jan 14, 2016
    Messages:
    42
    Likes Received:
    11
    I haven't been able to get it to launch even once, not sure if that counts as "usntable" since it's really a "non-starter", of course it's crashing at launch so that is a sign of instability. :)
     
    #2 woferry, Jan 19, 2016
  3. momoe

    momoe Member

    Joined:
    Apr 23, 2015
    Messages:
    74
    Likes Received:
    7
    mine will randomly crash or after a print, if I go to print another, my temp will rapidly flash 200 and then 0. have to shut down, I like MC but if I can't use it.....
     
    #3 momoe, Jan 19, 2016
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    MatterControl is written by MatterHackers and is only bundled with the Robo. MatterHackers has a forum on their own site, http://forums.matterhackers.com/ where you can get much more specific help. You will find that most of the old timers here have long abandoned MatterControl for other slicers, either free such as Cura, Slic3r, Repetier-Host or commercial such as Simplify3D.
     
    #4 WheresWaldo, Jan 20, 2016
    Mike Kelly likes this.

Share This Page