1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

My mods and upgrades

Discussion in 'Mods and Upgrades' started by WZ9V, May 2, 2016.

  1. WZ9V

    WZ9V Active Member

    Joined:
    Apr 9, 2016
    Messages:
    218
    Likes Received:
    64
    I bought some BluPrint, I think you use S3D, could you send some settings for me to start with? I'd be interested in the STL's also.
     
  2. WZ9V

    WZ9V Active Member

    Joined:
    Apr 9, 2016
    Messages:
    218
    Likes Received:
    64
    Tried troubleshooting Raspberry Pi and relay board and wouldn't work. Took them both out and set them up on the breadboard and it all worked again. Probably a bad crimp on one of my homemade cables.
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,962
    Likes Received:
    7,344
    Yes, I can get you BluPrint settings for S3D, but we crossed wires. I meant if you provided the STLs I could BluPrint them for you:)
     
  4. WZ9V

    WZ9V Active Member

    Joined:
    Apr 9, 2016
    Messages:
    218
    Likes Received:
    64
    OK. SInce I have things working again I can try and print it. If I end up having issues I may send them to you. I made the stock ones work with the glass I bought but I am working on some ideas for my aluminum plate that will allow use of 13 or so of the 15 inches using a silicone heater. My initial AC powered heater experiment is working quite well so far.
     

Share This Page