1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved My printer won't turn on

Discussion in 'Troubleshooting' started by Johndrindak, Feb 23, 2016.

  1. Johndrindak

    Johndrindak New Member

    Joined:
    Feb 20, 2016
    Messages:
    12
    Likes Received:
    0
    i was just about to print something when it suddenly shut off and initially when I turned it on the LED's would flicker. Now the machine doesn't do anything when I turn it on.

    -thanks
     
    #1 Johndrindak, Feb 23, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Bad power supply or A/C fuse?
     
    #2 mark tomlinson, Feb 24, 2016
  3. daniel871

    daniel871 Well-Known Member

    Joined:
    Apr 18, 2015
    Messages:
    1,322
    Likes Received:
    510
    Probably the fuse.

    Fair warning though, if something on the Robo is blowing fuses then things are probably getting ready to snowball.
     
    #3 daniel871, Feb 24, 2016
  4. Carlos Quiroz

    Carlos Quiroz New Member

    Joined:
    Feb 24, 2016
    Messages:
    5
    Likes Received:
    0
    Mine is the same! Won't do anything. It doesn't connect to repetier host nor moves back to 0,0,0 and the green LED on the bottom is turned on. Please help!
     
    #4 Carlos Quiroz, Feb 24, 2016
  5. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Did you just get your printer? Did you make sure the setting for the voltage switch in the back was set correctly?
     
    #5 danzca6, Feb 24, 2016
  6. Carlos Quiroz

    Carlos Quiroz New Member

    Joined:
    Feb 24, 2016
    Messages:
    5
    Likes Received:
    0
    Try using the new software MC. That worked for me
     
    #6 Carlos Quiroz, Feb 24, 2016
  7. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    Loose connection? Look underneath and see if the green LED is on.

    Check the fuse as well if the green LED is not on.

    If you're not comfortable working with electronics please contact robo3d for assistance.
     
    #7 Mike Kelly, Feb 24, 2016

Share This Page