1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer My R1 is stopping after callibration

Discussion in 'Troubleshooting' started by Kian Ghassemian, Feb 27, 2019.

  1. Kian Ghassemian

    Kian Ghassemian New Member

    Joined:
    Feb 27, 2019
    Messages:
    1
    Likes Received:
    0
    I am using a ROBO R1 plus and every time I go to print something and the calibration process ends, all the motors stop and the heat bed and extruder starts to cool down. There is also no error code appearing on the screen when this happens. Has anyone had this problem or does anyone know how to fix it? Thanks!
     
    #1 Kian Ghassemian, Feb 27, 2019
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I use to run into this with mattercontrol being goofed (can try a different slicer). Then experienced it again months later, but in the gcode log it was throwing an error I had to fix (thermal runaway), if I hadn't been hooked up and watched that log I never would have figured it out. Can you copy and paste your gcode log here for us to look at?
     
    #2 Geof, Feb 28, 2019
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Get us the details of the error as well please :)
     
    #3 mark tomlinson, Feb 28, 2019
    Geof likes this.

Share This Page