Unresolved My S3D first layer looks like a ballbag :/

kain0r3D · Jun 9, 2016

Ryan TeGantvoort said: ↑
Why do you have so many spacers on the X-axis End Stop Bolt? This is whats causing the issue. When it homes you are offsetting from the standard settings. So when it thinks it has homed its actually +15/20mm on X-Axis. You can easily see this in the video when it tries to go to the center while homing is it actually off to the right side when looking at the front of the Robo. If you want to keep it like that you will have to adjust X-Axis Auto-Level settings according to the offset/spacers you have applied. You will have to change your build size of the X-Axis as well. It would be best to do this in the firmware (configuration.h) so you don't lose your settings.

Around line 327
Code:
// Travel limits after homing
#define X_MAX_POS 220
#define X_MIN_POS 0
#define Y_MAX_POS 254
#define Y_MIN_POS 0
#define Z_MAX_POS 200
#define Z_MIN_POS 0
Around Line 363
Code:
// set the rectangle in which to probe
    #define LEFT_PROBE_BED_POSITION 15
    #define RIGHT_PROBE_BED_POSITION 205
    #define BACK_PROBE_BED_POSITION 230
    #define FRONT_PROBE_BED_POSITION 20
Click to expand...
YES!!!!

Sorry @mark tomlinson I thought i'd made the switch extensions known. I added them as Ryan said, to allow clearance for the 40mm fan. I wasn't keen on messing with the firmware, but I followed this guide: http://community.robo3d.com/index.p...ate-and-edit-robo-firmware-with-arduino.5227/

Easy.

Thanks again. Sorry for the confusion and waste of time, I was really put off by this issue and hadn't been able to get in touch with Robo. I can get back to my first layer now.

Unresolved My S3D first layer looks like a ballbag :/

kain0r3D New Member

Share This Page

About Us

Quick Navigation

Like us on Facebook

Useful Searches

Unresolved My S3D first layer looks like a ballbag :/

kain0r3D New Member

Share This Page