1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Need R2 software

Discussion in 'Software' started by Larry E Elliott, Jun 22, 2019.

  1. Larry E Elliott

    Larry E Elliott New Member

    Joined:
    Jun 22, 2019
    Messages:
    1
    Likes Received:
    0
    R2 Cura software link not working on Robo3D web site. Can someone supply a working link to a download location. Thanks
     
  2. albert3d

    albert3d Member

    Joined:
    Feb 3, 2018
    Messages:
    70
    Likes Received:
    28
    Here you go @Larry E Elliott. Now you can get the latest version of Cura as well and copy over the Robo profiles if you would like. I grabbed these installs when Robo was starting to wind down with the support of consumer printers. Figured we might lose download links someday.

    Install for Windows
    https://mega.nz/#!G7A1kYaL!ooCWNuMD0lknbBkj5Rzeh9iH82laYR2h7z30GPBnqMU

    Install for Mac
    https://mega.nz/#!PjZjCY6B!fbtt599v8MmJz60JvXfxTVV2MVWX6_WpzVmqgG5ikaY

    Profiles
    https://github.com/Robo3D/Slicing-Profiles
     
  3. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    UPDATED 3 Aug2019:
    Be aware that the current version of Cura is version 4.2.0.
    When I attempted to use Cura 4.2 initially, I found that the Octoprint extension was disabled for the registered printers (from an earlier version of Cura). I investigated the situation as it did not make sense.
    I found that you have to add a new printer, update or install the Octoprint extension, and then reboot the Cura program. Afterward, the Octoprint extension now works with the pre-existing printer profiles. I deleted the extra printer profile as it was superfluous.
     
    #3 tkoco, Jul 31, 2019
    Last edited: Aug 3, 2019
    Matt Zarkos likes this.
  4. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    Update:
    A link to the current version of RoboOS for the R2 printer has been added to the R2 FAQ in the Troubleshooting forum.
     

Share This Page