1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Newby in Bay Area CA

Discussion in 'United States of America' started by hybridman, Jul 27, 2015.

  1. hybridman

    hybridman New Member

    Joined:
    Jul 27, 2015
    Messages:
    18
    Likes Received:
    3
    Just got my first 3D printer -Robo3D. Overall I love the printer, still learning how to get better quality prints.
    A learning curve for sure.
    Found purple glue stick gives much better adhesion to glass than hairspray and tape (for my prints). Still working on improving quality as I found this weekend that even though Matter Control has fine detail print settings, they didnt really turn out too well. Need to look over the threads here to figure out settings...
     
    WheresWaldo and Mike Kelly like this.
  2. Aaron Mitchell

    Aaron Mitchell New Member

    Joined:
    Jul 4, 2015
    Messages:
    14
    Likes Received:
    4
    Welcome to the community...be sure to check out the Shoutbox if you need help...the guys there are always will to give tips, pointers and opinions...
     

Share This Page