1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Nothing heating up

Discussion in 'Troubleshooting' started by Ron W, Apr 16, 2015.

  1. Ron W

    Ron W Member

    Joined:
    Mar 31, 2015
    Messages:
    58
    Likes Received:
    10
    In the middle of a print, everything went cold, and now the extruder or the bed will not heat. I'm not really sure where to start investigating this, it's never happened before.

    Any suggestions would be appreciated.

    Ron
     
    #1 Ron W, Apr 16, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    You've done a power cycle? No error messages in software? Do you read temperatures?
     
    #2 Mike Kelly, Apr 16, 2015
  3. Ron W

    Ron W Member

    Joined:
    Mar 31, 2015
    Messages:
    58
    Likes Received:
    10
    Disregard.... everything working fine.... Apparently the power has to be in the on position.....:)

    That was embarrassing....
     
    #3 Ron W, Apr 16, 2015
    mark tomlinson and Printed Solid like this.
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    :)
     
    #4 Mike Kelly, Apr 16, 2015
  5. Ron W

    Ron W Member

    Joined:
    Mar 31, 2015
    Messages:
    58
    Likes Received:
    10
    just a filament jam in the middle of the print and the wife turned it off....
     
    #5 Ron W, Apr 16, 2015
  6. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    One time I called customer support for a carpet cleaner because it had stopped working.

    It was out of water.

    Happens to the best of us.
     
    #6 Mike Kelly, Apr 16, 2015

Share This Page