1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered PLA stuck, can't remove extruder, Robo 3D R1 Plus

Discussion in 'Troubleshooting' started by Michele Beyer, Nov 22, 2015.

  1. Michele Beyer

    Michele Beyer Member

    Joined:
    Nov 16, 2015
    Messages:
    62
    Likes Received:
    7
    Hello,

    I've got some PLA stuck in my printer and I can't get it out. I tried heating up the extruder and pulling it out and also tried extruding it, but nothing happens. So I looked at some videos of how to remove the extruder and clean it, but I can't seem to figure this out. Supposedly there are 2 screws I should see and that's all I should have to unscrew to remove the extruder. However, I don't see those 2 screws anywhere. Please help :) I have the Robo 3D R1 Plus.

    Thank you!
     

    Attached Files:

    #1 Michele Beyer, Nov 22, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #2 mark tomlinson, Nov 22, 2015

Share This Page