1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

PLA suggestions

Discussion in 'General Questions' started by BJS227, Jul 13, 2019.

  1. BJS227

    BJS227 Member

    Joined:
    Sep 19, 2017
    Messages:
    42
    Likes Received:
    7
    With robo not selling pla anymore, what are some suggestion on what and where to purchase spools. TIA!
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Anywhere you like, most PLA is fine. If you want excellent quality then use a brand-name (like Colorfabb: https://colorfabb.com/)
     
    Geof likes this.
  3. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    I agree with Mark, buy a name brand filament. Low cost, no-name filament may save you a buck or two, but you can end up with an assortment of problems which can cause you untold grief.
     
    Geof likes this.

Share This Page