1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Print Head Too high

Discussion in 'Troubleshooting' started by Mark Orban, Dec 31, 2015.

  1. Mark Orban

    Mark Orban New Member

    Joined:
    Dec 31, 2015
    Messages:
    1
    Likes Received:
    0
    So I just got my robe r1 +plus and set it up and tried to print the calibration box from the matter control library. Unfortunately, the extruder always goes too high above the print head even when I tried to control it from the matter control settings. How do you make the extruder automatically go to the correct height?
     
    #1 Mark Orban, Dec 31, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #2 mark tomlinson, Dec 31, 2015

Share This Page