1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Printer stops immedietly after starting

Discussion in 'Troubleshooting' started by sd463d, Nov 25, 2017.

  1. sd463d

    sd463d New Member

    Joined:
    May 2, 2016
    Messages:
    9
    Likes Received:
    1
    Okay so wondering if anyone has experienced this. I load a print from the computer and both the element and bed heat up just fine. It homes the axis and probes the bed and then immediately stops the print and becomes unresponsive. I notice then afterwards both the element and bed both turn off. Any ideas? Thanks!
     
    #1 sd463d, Nov 25, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Make sure the little fan under the bottom cover is spinning 100% of the time.
     
    #2 WheresWaldo, Nov 26, 2017
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Check the GCode terminal (rad it all the way back to the start) and see if there are any errors in there.
    I would suspect there is a "Temperature fell too much during print" error in there, but read it and see what is going on.
     
    #3 mark tomlinson, Nov 26, 2017

Share This Page