1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Printer Won't Turn On

Discussion in 'Troubleshooting' started by Ronaks, Feb 17, 2016.

  1. Ronaks

    Ronaks New Member

    Joined:
    Feb 17, 2016
    Messages:
    1
    Likes Received:
    0
    Hey guys, just got my printer. I had it working and on. Once I connected it to the software I pressed print. I didn't see that it was too close to a wall and it bumped into it for like 3 seconds and then just turned on. Now it won't turn back on period. Not even led lights. I don't think I blew a fuse since it was the bed/motors that should have been effected but I am unsure. Any help would be great.


    Thanks.
     
    #1 Ronaks, Feb 17, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Look at the fuse. The A/C fuse that is built into the connector where you plug in the A/C cable to the printer from the wall. '
    If you unplug the cord and look carefully at the connector it tells you how to snap it open and get to the fuse.
     
    #2 mark tomlinson, Feb 17, 2016
    Mike Kelly likes this.

Share This Page