1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printing off center

Discussion in 'General Questions' started by Jack Brannan, Dec 28, 2015.

  1. Jack Brannan

    Jack Brannan New Member

    Joined:
    Dec 27, 2015
    Messages:
    8
    Likes Received:
    0
    So I have calibrated my 3D printer to be level but it is also printing slightly off center. I am worried hat this will effect a larger print that I do. Is there any way to calibrate where it prints?
     
    #1 Jack Brannan, Dec 28, 2015
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    @Jack Brannan, Didn't I answer this in another thread! Ignore the square on the print bed, it has no basis in reality and is only there to look pretty.

    Just saw it wasn't your post, someone else asked the same question. This comes up almost every time someone unpacks and starts up their Robo for the first time, wished it was in a "need to know" sticky.
     
    #2 WheresWaldo, Dec 28, 2015
    Last edited: Dec 28, 2015
    mark tomlinson and Jack Brannan like this.
  3. Jack Brannan

    Jack Brannan New Member

    Joined:
    Dec 27, 2015
    Messages:
    8
    Likes Received:
    0
    Oh thank you very much! That needs to be in the getting started video that comes with the printer!
     
    #3 Jack Brannan, Dec 28, 2015

Share This Page