1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Problem connecting after upgrade

Discussion in 'Troubleshooting' started by Bobocop, Jan 6, 2016.

  1. Bobocop

    Bobocop New Member

    Joined:
    May 27, 2015
    Messages:
    22
    Likes Received:
    1
    I just installed the new lead screw upgrade and downloaded and uploaded the Lead screw upgrade firmware
    and now the printer will not connect to my computer.
    Does anyone have any ideas on what i can check for ?
     
    #1 Bobocop, Jan 6, 2016
  2. Bobocop

    Bobocop New Member

    Joined:
    May 27, 2015
    Messages:
    22
    Likes Received:
    1
    I was just wondering if it has anything to do with the firmware.
    also I cannot figure out how to make it search for other ports in Cura, the only options it gives me is COM4 or AUTO, anyone have any ideas ?
     
    #2 Bobocop, Jan 9, 2016
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Try a different port or better quality USB cables. This fixes about 99.9% of communication issues. Firmware has nothing to do with this, just a coincidence if it happened immediately after upgrading.
     
    #3 WheresWaldo, Jan 9, 2016
  4. Bobocop

    Bobocop New Member

    Joined:
    May 27, 2015
    Messages:
    22
    Likes Received:
    1
    Ive tried plugging in to all my 3 ports and using my inkjet printer cable but in Cura it just keeps saying "ERROR: No more baudrates to test" and it will not connect.
    So annoying, the upgrade installation went nice and smooth and now i can't connect to use it.
     
    #4 Bobocop, Jan 9, 2016
  5. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Arduino 2650 Mega likes 250,000 baud, but it is adjustable in firmware, try other baud rates in firmware. It is located in Configuration.h about line 28.
     
    #5 WheresWaldo, Jan 9, 2016
    mark tomlinson likes this.
  6. Bobocop

    Bobocop New Member

    Joined:
    May 27, 2015
    Messages:
    22
    Likes Received:
    1
    Thanks, It does say 250,000 but i will try changing it
     
    #6 Bobocop, Jan 11, 2016
  7. Bobocop

    Bobocop New Member

    Joined:
    May 27, 2015
    Messages:
    22
    Likes Received:
    1
    Ok i finally got it to connect, I deleted the Arduino software from my computer, redownloaded and reinstalled then uploaded the Lead Screw firmware and it connects now. Strange.

    Thanks WheresWaldo
     
    #7 Bobocop, Jan 11, 2016
    mark tomlinson likes this.

Share This Page