Unanswered Problems with printing Cura files.

I have not been able to have a successful Cura print on my ROBO3D. I have been printing successfully using mattercontrol and matterslice for awhile now but even in the partial prints that I get Cura is far superior especially in support material generation but whether I print from an SD card on my LCD controller or I unplug the controller and use mattercontrol with the Cura slicer or even strait from Cura the print will reach a point within the first 10-20% and just stop and sit there. I have tried every variation I can think of but the only thing that seems to work are models that use matterslice. Any help is greatly appreciated.

 

Is there a way to view the communication log with the lcd controller or should I just run a small print connected to the computer?

 

Errors usually show up on the LCD. Are you disconnected from the computer when you get the stoppage?