1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R2-how to set bed temp?

Discussion in 'Troubleshooting' started by Robert DuBard, Jan 8, 2018.

  1. Robert DuBard

    Robert DuBard New Member

    Joined:
    Jan 8, 2018
    Messages:
    1
    Likes Received:
    0
    Sorry for the total noob question, but I'm trying to run the test print, and it isn't sticking to the bed.
    I have set z-offset and levelled, so that isn't the problem.
    I only have ABS, and the file (Filament_Tube_Clips.gcode) seems to preset the bed temp for PLA. I am pretty sure the 40C temp difference is a factor.
    So, how do you change the bed temp for an existing file?
    -Thanks
     
    #1 Robert DuBard, Jan 8, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    .gcode is not worth the hassle to set temp for.

    You want to find the .stl for the filament tube clips. Slice it in your slicer (where you can specify bed temp) then load it. the R2 should have come with a spool of blue PLA. ?
     
    #2 Geof, Jan 8, 2018

Share This Page