1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R2 v2 bed question

Discussion in 'Troubleshooting' started by J.P., Jan 24, 2018.

  1. J.P.

    J.P. New Member

    Joined:
    Jul 11, 2017
    Messages:
    8
    Likes Received:
    0
    I have one of the v2 beds that connect directly to the cable instead of through the PoGo board. My problem is that things stick a little TOO well to the plate. I've torn the top layer of the build plate but it looks like it could be replaced? Does Robo sell such a thing? Do I need to replace the whole bed... again? is anyone else having adhesion issues with the new plates? I've contacted them but thought it might be useful to put this on the forum for other users that might have the same issues.
     
    #1 J.P., Jan 24, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    They use a buildtak sheet, you can get new sheets from buildtak or robo. To close of a first layer will adhere to much. Some materials stick to aggressively and need a little glue stick. Amazon also has buildtak :)
     
    #2 Geof, Jan 24, 2018
  3. Redriche

    Redriche Member

    Joined:
    Jun 7, 2017
    Messages:
    66
    Likes Received:
    16
    Also try lowering you need temp by 5°-10°'s


    Sent from my iPhone using Tapatalk
     
    #3 Redriche, Jan 25, 2018

Share This Page