1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered RAMPS burned out, robo3d store replacement isnt the same ramps, wont work!

Discussion in 'Troubleshooting' started by robohobo, Feb 17, 2017.

Thread Status:
Not open for further replies.
  1. robohobo

    robohobo New Member

    Joined:
    Feb 17, 2017
    Messages:
    1
    Likes Received:
    0
    I got a ramps 1.4 from amazon and that would work either, there was no where to plug it in!

    Here is the ramps that came with my robo3d R1+:
    [​IMG]

    ROBOstore ramps
    [​IMG]



    See the pins along the left side that power the fans? The white clips wont plug into this, its the exact same configuration the amazon ramps had, i tried to plug it in it wouldnt let me. In fact any where you see white clips wont plug into any other ramps board, and i cant wire them directly to the pins! Where can i find a ramps like i have?
     

    Attached Files:

    #1 robohobo, Feb 17, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    #2 Geof, Feb 17, 2017
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page