1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recommend filament for replacement and upgraded parts

Discussion in 'Printing Filament' started by Quest, Jan 23, 2016.

  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Feb 18, 2015
    Likes Received:
    @KTMDirtFace this is a prime example of where most people would blame the slicer and then recommend S3D, but you already use S3D so that is just more proof it is settings and calibration more so than what slicer you use. I know you calibrated your printers so mechanically they are likely pretty close, now it's time to fine tune the slicer settings.

Share This Page