1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Replacing Motor Driver Belt Robo R2

Discussion in 'Troubleshooting' started by gneymark, Jul 31, 2018.

  1. gneymark

    gneymark New Member

    Joined:
    Jul 31, 2018
    Messages:
    2
    Likes Received:
    0
    One of the motor driver belts (Back top right corner if you're facing the printer) has frayed and no longer works. Does anyone have any experience replacing these. I am trying to get the back panel of the printer off so I can pull the belt off what it is difficult to figure out how it comes off. Any suggestions on how to replace the belt? I figure it would be easier to replace the belt myself rather than sending the printer to Robo since these belts are cheap on Amazon.

    upload_2018-7-31_16-44-3.jpeg
     

    Attached Files:

    #1 gneymark, Jul 31, 2018
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    There are 9 screws (IIRC) around the top of the gantry. It will lift off after you remove them. You should then have access to all the belts.
     
    #2 WheresWaldo, Aug 1, 2018
  3. gneymark

    gneymark New Member

    Joined:
    Jul 31, 2018
    Messages:
    2
    Likes Received:
    0
    Thank you! That is exactly what I needed to know.
     
    #3 gneymark, Aug 1, 2018

Share This Page