1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Robo c2 extruder hits the printing floor

Discussion in 'Troubleshooting' started by Aamon, Jul 7, 2020.

  1. Aamon

    Aamon New Member

    Joined:
    Jul 7, 2020
    Messages:
    1
    Likes Received:
    0
    Hi everybody! I have a problem whit my robo c2, when i try to print something, the extruder hits the printing floor, the z offset is regulated with the tool of the printer.
    How can i fix it?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,445
    Likes Received:
    7,187
    This was in the R1 section, I am moving your post into the C2 area.
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,445
    Likes Received:
    7,187
    Either your Z offset is wrong (make sure it is a negative number) or the IR sensor is not working correctly.
     
    Geof likes this.

Share This Page