1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

robo E3 problems

Discussion in 'Troubleshooting' started by Lesley Galyas, Jan 25, 2024.

  1. Lesley Galyas

    Lesley Galyas New Member

    Joined:
    Jan 25, 2024
    Messages:
    1
    Likes Received:
    1
    I need help with my school robo E3 3D printer. I'm the STEM Specialist in a public schools in NM. We have problems with the filament Guide tube getting clogged to no end. I don't know the size of the guide tube and where to get them. Thanks!
     
    mark tomlinson likes this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    moved to E3 forum.
    @Geof can probably assist you.

    The size of the tube is likely 2mm PTFE (but I don't have one to check)
    If it is 2mm, then Amazon sells it.
     
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sorry for the late reply. It’s just standard ptfe tubing. Nothing special. Most times the issue is right where the tubing seats. Normally can clip off the end. Push it back in and continue on. Sorry sold off my E3 so haven’t got one to take photos of.
     
    mark tomlinson likes this.

Share This Page