1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo print - zero layer top/bottom

Discussion in 'Troubleshooting' started by Baron Reyna, Feb 26, 2021.

  1. Baron Reyna

    Baron Reyna New Member

    Joined:
    Feb 23, 2021
    Messages:
    3
    Likes Received:
    2
    Howdy!

    One of the projects we are attempting to print has in the instructions to not include a top or bottom layer. Roboprint does allow me to change those settings for the top amd bottom layer but 1 layer is the smallest I can go.

    Any ideas or suggestion?
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,340
    Hi there. I do not think you can remove those layers in Robo print . But you can download cura and use the standard profile for the flash forge adventurer and that should let you print with any settings you’d like.
     
    Baron Reyna and mark tomlinson like this.
  3. Baron Reyna

    Baron Reyna New Member

    Joined:
    Feb 23, 2021
    Messages:
    3
    Likes Received:
    2
    Geof, that is very helpful. I did download Cura but because I did not see the E3 listed I was not comfortable continuing. ~thanks!!!
     
    mark tomlinson likes this.
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,340
    The E3 is a rebrand of the flash forge adventurer 3. All the insides are the same :). The cura for the adventurer will work the E3
     
  5. Baron Reyna

    Baron Reyna New Member

    Joined:
    Feb 23, 2021
    Messages:
    3
    Likes Received:
    2
    Great news! Thanks a bunch.
     
    Geof likes this.

Share This Page