1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Switched to Cura

Discussion in 'Software' started by Lou Neckles, Apr 13, 2018.

  1. Lou Neckles

    Lou Neckles New Member

    Joined:
    Apr 13, 2018
    Messages:
    6
    Likes Received:
    0
    Can anyone help me with the start & stop gcode needed to use cura.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,442
    Likes Received:
    7,056
    Might want to be a bit more specific on version, there are a few threads on here with Cura information, but the version of Cura matters a lot
     
  3. Lou Neckles

    Lou Neckles New Member

    Joined:
    Apr 13, 2018
    Messages:
    6
    Likes Received:
    0
    Sorry, I'm using Cura 3.2.1. I was wondering if the same Gcodes in mattercontrol would work?
     

Share This Page