1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Thermistor mix up

Discussion in 'Troubleshooting' started by Ian Kenny, Dec 18, 2013.

Thread Status:
Not open for further replies.
  1. Ian Kenny

    Ian Kenny New Member

    Joined:
    Dec 18, 2013
    Messages:
    4
    Likes Received:
    0
    Hi the temperature of the extruder is reported in Repetier as the temperature of the bed. So when I check by clicking heat extruder Repetier shows the bed heating up, does this need a rewire?
     
    #1 Ian Kenny, Dec 18, 2013
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Wow. That sounds like a wiring issue all right.
     
    #2 mark tomlinson, Dec 18, 2013
  3. Ian Kenny

    Ian Kenny New Member

    Joined:
    Dec 18, 2013
    Messages:
    4
    Likes Received:
    0
    Anyone any idea / help / instructions for rewire?
     
    #3 Ian Kenny, Dec 18, 2013
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    swap t0 and t1 on the ramps board
     
    #4 Mike Kelly, Dec 18, 2013
Thread Status:
Not open for further replies.

Share This Page