tidy up your wiring.

before, Note: it didn't come this way, i unbundled all the tape and this was how it looked,


after


all stepper motor wiring upgraded to shielded wire, added clamps and tie downs where needed.

 

tie downs for exposed wiring

 

yes it is, im using a dedicated 24v power supply for the heat bed, ssr is controlled by the heat bed output from the ramps board.

 

I can't tell by your pics but what did you do with the wires running to the hot bed. They rub on the threaded rods for the Z axis. Since it looks like I have to take apart my extruded I might as well fix that while I have the case off.

 

In my last photo set above the first picture shows my wiring to for the heated bed, (both red wires, not stock im using a kapton heater) but you see how its ran in that photo