1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Titan extruder firmware?

Discussion in 'General Questions' started by Robert J., Jan 19, 2017.

Thread Status:
Not open for further replies.
  1. Robert J.

    Robert J. Member

    Joined:
    Dec 23, 2015
    Messages:
    46
    Likes Received:
    7
    I just installed the Titan extruder on my Robo 3D printer. Do I need to make firmware updates or changes? I just attempted to do it real quick print and it look like it was over extruding. And I already have my shooter turned down because I was over extruding on my old printhead. Any help for a starting point?

    Sent from my SM-G930V using Tapatalk
     
    #1 Robert J., Jan 19, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Jan 19, 2017
    Geof likes this.
Thread Status:
Not open for further replies.

Share This Page