1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Trouble with model when printing...

Discussion in 'Troubleshooting' started by jerome, Nov 23, 2014.

Thread Status:
Not open for further replies.
  1. jerome

    jerome New Member

    Joined:
    Apr 13, 2014
    Messages:
    2
    Likes Received:
    0
    Hello, My name is Jerome and i live in France.

    I've purchased the ROBO3D from 6 month now.
    I want to print a piece but there is a little problem when i watch it in CUra (or another program, i've test matter control too).
    here the piece that i want:
    Capture d’écran 2014-11-23 à 10.39.12.png

    But When i watch the layer, it create me some face:
    Capture d’écran 2014-11-23 à 10.39.53.png Capture d’écran 2014-11-23 à 10.40.06.png Capture d’écran 2014-11-23 à 10.40.20.png

    I think about a graphic problem from my computer, and in print it.
    But it create really hard face, 5 to 10 layer width.

    i try with another part and it make same thing...

    Someone here can help me? i really need to print this
    If you want i can send you the file.

    Thanks and sorry for my poor english.

    Jerome
     
    #1 jerome, Nov 23, 2014
  2. Peter Krska

    Peter Krska Active Member

    Joined:
    Nov 30, 2013
    Messages:
    766
    Likes Received:
    229
    What is the problem exactly? Post the object here and we'll see if anyone else has that problem.

    What I see is the infill
    Not sure what the problem is but once the thing is done printing you won't see any of that infill.
     
    #2 Peter Krska, Nov 23, 2014
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    hard to say, but is the center solid and it is not supposed to be?
     
    #3 mark tomlinson, Nov 23, 2014
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #4 Mike Kelly, Nov 23, 2014
  5. jerome

    jerome New Member

    Joined:
    Apr 13, 2014
    Messages:
    2
    Likes Received:
    0
    Yeah the center is solid but it not supposed to be.
    I try running nettfabb' repair and it solve my problem.
    I don't know why....

    If someone can bring me some advice...

    Thanks to you all.

    one more question : What is the best PLA or ABS ?
     
    #5 jerome, Nov 24, 2014
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Netfabb may tell you what error it corrected. Usually non-manifold issues are common.
    ABS is difficult to print (without a heated chamber it is tough to avoid warp).
     
    #6 mark tomlinson, Nov 24, 2014
Thread Status:
Not open for further replies.

Share This Page